433MHz Universal Wireless Remote Control Switch DC 6V 12V 24V 2 Channel RF Receiver, 50m Remote Control, For Light/Gate/Motor/DIY

Parameter RF frequency: 433MHz Control distance: 50 meters in open space Material: Plastic Support coding: 1527 leaning code Battery: CR2016 Contain Size: 30*60*13mm remote control (3 buttons) parameter RF frequency: 433MHz Control distance: 50 meters in open space Material: Plastic Support coding: 1527 leaning code Battery: CR2016 Contain Size: 60*30*13mm circuit diagram If you have any questions, please contact , we will try our best to answer, we also have video tutorials, please scan the QR code below to enter the video channel. Thanks. Operating mode Current mode: 1. Press and hold a button, relay "1" will be turned on; 2. Release the button, this relay "1" will be turned off. Toggle mode: 1. Press "a" button, relay "1" will be turned on; 2. Press "a" button again, this relay "1" will be turned off. Latched Mode (this mode requires a remote control with at least 3 buttons or more): 1. Press "a" button, relay "1" will be turned on; 2. Press "b" button, relay "2" will be turned on, at the same time relay "1" will be turned off. 3. Press "c" button, both relays "1" and "2" will be turned off. How to set up Mode 1. memontary: Press the learning button on the switch 1 time, Press each remote button 1 time, successful 2.Toggle mode: Press the learning button on the switch 2 times, Press each remote button 1 time, successful 3.Latched mode: Press the learning button on the switch 3 times, press a button 1 time, press b button 1 time, successful Reset1. Press the learn button 8 times to clean data, then all remote controls cannot control this receiver Note:1. Reset before you want to change the operating mode of a remote control. 2. After resetting, all remote controls can no longer work. 3. Replace the battery in time when the remote control voltage is low. To get the stronger signal transmission. 4. Stretch the antenna on the receiver slightly for better signal reception. 5. The remote control must have less 3 or more buttons if you want to set up locked mode. Please contact if you have any questions. Thanks.