Pure Sine Wave Inverter DC 12v/24v to AC 220V — 2000W / 3000W / 4000W / 5000W Power Converter (Solar)

Important safety and installation notes: - Do NOT connect this inverter to the utility power grid. The AC output must not be tied into mains supply or used to feed into the grid. The AC output lines are live — avoid touching them while the unit is powered. - Both AC output conductors are live lines; there is no neutral/ground on either output. Do not use either output conductor as a grounding conductor. - Install the inverter directly to the load. Do not insert an air switch, circuit breaker or residual current (leakage) protection device between the inverter and the load. Placing such devices in-line may render protection ineffective and can damage the inverter. - Wiring and battery guidance: the battery connected to this inverter can supply more energy than the device’s instantaneous consumption. The DC current from the battery can be very high — keep the battery-to-inverter wiring as short as possible and use the original cable provided. Unauthorized extension of the battery cable can cause insufficient input current/voltage. - If you must extend the battery cable, the extension conductor’s diameter must be roughly doubled (about twice as thick as the original wiring). Even with correctly sized wire, extension length is not recommended to exceed 1 meter. - Performance note: for purely inductive loads, the pure sine wave inverter’s load capacity is 95%. Compatibility: converts DC 12v/24v input to AC 220V output and is available in 2000W, 3000W, 4000W and 5000W power ratings.