TOOL1SHOoo PVC Plastic Bending Machine Heater Hot Heating Bender Acrylic 24"inch 600mm 110V

Practical and Portable: Lightweight and practical. Save space, heat bending plastic sheets of various materials, such as the thickness of more than 6mm, can be equipped with multiple heaters to heat multiple bending points at a time. The power supply and the water pipe are respectively connected at both ends. The hydroelectric separator is safe and intuitive, easy to plug and unplug, easy to store, and easy to assemble with the workbench. Work in Pair: If the thickness of acrylic material is beyond 0.24" (6 mm), you can choose to apply two plastic bending strip heater to heat both top and bottom of the material at the same time Safety Water Circulation Cooling: There is water circulation cooling on both sides of the plastic sheet bender heating tube to ensure that there will be no thermal deformation except where heating is needed About Brand: TOOL1SHOoo COLLECTION is a professional tool and equipment company aiming to provide quality products and services. If you have any problems, please feel free to contact us and we will reply to your in 24 hours. 100% Quality Assurance: We ship directly from the US warehouse. Feel free to contact us if you have any questions. We will provide the best suitable solutions for you. We are committed to provide best service for every customer! [Instruction] Keep a cooling tank (barrel) of more than 30 liters. First, connect the heater body and the submersible pump with a silicone hose. Place the submersible pump in the cooling bucket, connect the power supply of the pump, and wait for the water to circulate out. (note: The water temperature of the machine will keep rising for a long time. Please replace the cold water clearly. The temperature of the circulating water should not drop abruptly. When the water temperature exceeds 50 degrees, the power supply of the heater should be cut off in time, and the circulating water should be replaced later.) Connect the thermostat with the hot bender and connect it to 220v power supply. Adjust the knob of the thermostat controller. The clockwise direction is to raise the temperature, and vice versa. When adjusting, it is not appropriate to rotate too fast in order to avoid damaging the thermostat. (note: It is advisable to slowly adjust the thermostat to a reddish heat pipe. Excessive temperature will cause damage to the hot bending material and affect the service life of the hot bender). When the heating pipe reaches the required temperature, it can place the plastic sheet which needs to be hot-bended on the heating trough. When the sheet is soft enough to be folded manually, it can bend at various angles. According to the different materials, the setting time is different. Please determine the setting time according to the actual situation.